#
# Licensed to the Apache Software Foundation (ASF) under one
# or more contributor license agreements.  See the NOTICE file
# distributed with this work for additional information
# regarding copyright ownership.  The ASF licenses this file
# to you under the Apache License, Version 2.0 (the
# "License"); you may not use this file except in compliance
# with the License.  You may obtain a copy of the License at
#
#  http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing,
# software distributed under the License is distributed on an
# "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY
# KIND, either express or implied.  See the License for the
# specific language governing permissions and limitations
# under the License.
#

# Settings this app defines.
syscfg.defs:
    BLE_STRESS_TEST_ROLE:
        description: 0 - TX device, 1 - RX device
        value: 0

    BLE_STRESS_REPEAT:
        description: Number of times to repeat each stress test use case
        value: 50

    BLE_STRESS_UUID_BASE:
        description: Part of the test UUID that is specific to the current
                     device couple.
        value: ((uint8_t[13]){0xA5, 0x4A, 0xB4, 0x44, 0xC3, 0xBF, 0xB5,
                              0xF8, 0xF9, 0x42, 0x83, 0xA1, 0xDA})

# Settings this app overrides.
syscfg.vals:
    # Change these settings:

    # Set 0 to print all debug logs, but keep in mind that plenty of
    # adv packets will be lost during scan tests.
    LOG_LEVEL: 1

    # The maximum number of concurrent connections. For some devices, this
    # value will need to be reduced due to the RAM capacity.
    BLE_MAX_CONNECTIONS: 50

    # Should not change these settings:

    # Enable Extended Advertising
    BLE_EXT_ADV: 1

    # Max advertising data size
    BLE_EXT_ADV_MAX_SIZE: 1650

    # Number of multi-advertising instances. Note that due
    # to historical reasons total number of advertising
    # instances is BLE_MULTI_ADV_INSTANCES + 1 as instance
    # 0 is always available
    BLE_MULTI_ADV_INSTANCES: 2

    # Controller uses msys pool for storing advertising data and scan responses.
    # Since we advertise a lot of data (~4k in total) at the same time we need
    # to increase block count.
    MSYS_1_BLOCK_COUNT: 50

    #
    BLE_L2CAP_COC_MAX_NUM: 2

    # Enable 2M PHY
    BLE_LL_CFG_FEAT_LE_2M_PHY: 1

    # Enable CODED PHY
    BLE_LL_CFG_FEAT_LE_CODED_PHY: 1